Zum Hauptinhalt wechseln

Einleitung

This guide demonstrates how to replace a screen. You will need a one mm Phillips head screwdriver. Keep in mind that the Creative Zen Vision was released in 2005 and discontinued shortly after that. So it may be difficult to obtain a new screen to use as a replacement.

  1. Pop off the top plastic on the device with a flat tool like a flathead screwdriver. Unscrew and remove the two exposed Phillips head screws.
    • Pop off the top plastic on the device with a flat tool like a flathead screwdriver.

    • Unscrew and remove the two exposed Phillips head screws.

  2. Work your way around the recess of the device with a flat tool like a flathead screwdriver. Don't try attempt to open it from the recess between the buttons and the device.
    • Work your way around the recess of the device with a flat tool like a flathead screwdriver.

    • Don't try attempt to open it from the recess between the buttons and the device.

  3. Disconnect the wire from the bottom device. Handle with care as the wires tend to  disconnect easily. Handle with care as the wires tend to  disconnect easily.
    • Disconnect the wire from the bottom device.

    • Handle with care as the wires tend to disconnect easily.

  4. Laptop-Akkus

    Batteries for all the top PC brands, backed by our Quality Guarantee.

    Jetzt kaufen

    Laptop-Akkus

    Batteries for all the top PC brands, backed by our Quality Guarantee.

    Jetzt kaufen
  5. In the top right corner, pull the black foam square off to separate the hard drive from the screen.
    • In the top right corner, pull the black foam square off to separate the hard drive from the screen.

    • Handle with care as the hard drive also comes off easily.

  6. Unscrew the seven screws placed around the mother board.
    • Unscrew the seven screws placed around the mother board.

    • You will need a one millimeter Phillips head screwdriver.

    • The screws are small, so keep them safely.

  7. Flip your device upside down so that the motherboard will loosen. Detach the connector from the motherboard. Detach the connector from the motherboard.
    • Flip your device upside down so that the motherboard will loosen.

    • Detach the connector from the motherboard.

  8. Tilt the screen diagonally.  Separate the screen and motherboard from the device frame. Lift the light gray flap to detach the screen from the motherboard.
    • Tilt the screen diagonally. Separate the screen and motherboard from the device frame.

    • Lift the light gray flap to detach the screen from the motherboard.

  9. Separate the clear screen frame from the digital display. Separate the clear screen frame from the digital display.
    • Separate the clear screen frame from the digital display.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Kirstie G

Mitglied seit: 12.10.2016

410 Reputation

4 Anleitungen geschrieben

Team

Texas Tech, Team 12-1, Bennett Fall 2016 Mitglied von Texas Tech, Team 12-1, Bennett Fall 2016

TTU-BENNETT-F16S12G1

4 Mitglieder

4 Anleitungen geschrieben

Kommentar hinzufügen

Statistik anzeigen:

Letzte 24 Stunden: 3

Letzte 7 Tage: 4

Letzte 30 Tage: 22

Insgesamt: 465