Zum Hauptinhalt wechseln
  1. Locate a spot in the middle of the rain garden where the soil is bear/free from plants.
    • Locate a spot in the middle of the rain garden where the soil is bear/free from plants.

    • We need to install in the middle of the rain garden to ensure quality data.

  2. At the selected location, use a post hole digger to make a hole for the node. Take your time so as to not disturb the soil too much.
    • At the selected location, use a post hole digger to make a hole for the node.

    • Take your time so as to not disturb the soil too much.

    • Use a tape measure to make sure the hole is 3 feet deep.

    • The soil removed from the hole will fill roughly 2 buckets

    • Fill the first bucket with topsoil

    • When the soil begins to look like clay, switch to filling the second bucket

  3. Set the GI node into the 3 ft hole. Do your best to make sure it is straight in the ground.
    • Set the GI node into the 3 ft hole.

    • Do your best to make sure it is straight in the ground.

    • Pack the topsoil from the first bucket around the node to make sure it is secure in place. You shouldn't need to use any soil from the second bucket

    • If the surrounding plants are too tall, shading the solar panel, use the shears to trim the plants.

    • Once installed, confirm the GI node is reporting to the internet by going to its designated website.

Ziellinie

Brooke Mason

Mitglied seit: 29.05.2019

2.865 Reputation

17 Anleitungen geschrieben

Team

Open-Storm Mitglied von Open-Storm

Community

20 Mitglieder

24 Anleitungen geschrieben

Kommentar hinzufügen

Seitenaufrufe:

Letzten 24 Stunden: 0

Letzten 7 Tage: 0

Letzten 30 Tage: 4

Insgesamt: 26