Einleitung
If your HEC Remote Control stops working properly due to issues like, sticky buttons, a bad LED, or no response from the remote, the use this guide to repair your HEC Remote Control.
The remote control works by sending infrared (IR) signals to communicate with your device. Some symptoms of a faulty IR signal could be buttons not working or corrosion of battery terminals.
Before disassembly, please check for dirt buildup in and on the remote, dead batteries, and battery corrosion. Many signal issues can be resolved by performing a simple cleanup process on the remote.
Finally, remove batteries and disconnect any power source to the remote to prevent further damage.
Was du brauchst
-
-
-
Use a spudger to open HEC Remote Control
Frag FixBot
-
-
-
To reassemble your device, follow these instructions in reverse order.
Rückgängig: Ich habe diese Anleitung nicht absolviert.
2 weitere Personen haben diese Anleitung absolviert.
Team
Cal Poly, Team 6-1, Regan Fall 2011 Mitglied von Cal Poly, Team 6-1, Regan Fall 2011
CPSU-REGAN-F11S6G1
4 Mitglieder
23 Anleitungen geschrieben
