Diese Version enthält möglicherweise inkorrekte Änderungen. Wechsle zur letzten geprüften Version.
Was du brauchst
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Open the lid as far as possible.
-
Slide your spudger into the bezel of the laptop until it appears on the other side.
-
Make your way around the bezel with the spudger while gently prying up the bezel to snap it out of place.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Hold the bezel on both sides, and twist the bezel repeatedly until the bottom bezel snaps out of place.
-
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Unscrew the four silver 4mm Phillips #0 screws on the edges of the display.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Gently lift the LCD panel out of the body and lower it onto the keyboard deck.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Identify the eDP 30-pin connector and use the sharp end of the spudger to peel off a corner of the tape over the connector.
-
Use your fingers to peel off the rest of the tape.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Hold both sides of the tape and gently push back the connector to disconnect the display.
-
Rückgängig: Ich habe diese Anleitung nicht absolviert.
2 weitere Nutzer:innen haben diese Anleitung absolviert.