How to Disable Auto Boot

Geschrieben von: Jeff Suovanen

Kommentare: 0
Favoriten: 0
Vollendete Reparaturen: 2

Schwierigkeitsgrad

Einfach

Schritte

Zeitaufwand

5 Minuten

Einleitung

The Auto Boot feature powers on your laptop as soon as you open the lid, so it must be disabled before undertaking certain repairs. Auto Boot can be found on 2016 (and newer) MacBook Pros and 2017 (and newer) 12" Retina MacBooks.

This guide will walk you through the process of disabling Auto Boot, and then re-enabling it when your repair is complete.

1. Schritt How to Disable Auto Boot

To launch Terminal, you can either use Spotlight Search or navigate to Applications / Utilities in Finder and double click the Terminal icon.

Power on your Mac and launch Terminal.
- To launch Terminal, you can either use Spotlight Search or navigate to Applications / Utilities in Finder and double click the Terminal icon.

Bearbeiten

2. Schritt

Copy and paste the following command (or type it exactly) into Terminal:

Copy and paste the following command (or type it exactly) into Terminal:
- sudo nvram AutoBoot=%00
Press [return].
- Your [return] key may also be labeled ⏎ or [enter].
If you are prompted for an administrative password, type the password and press [return].
- Your password will not be displayed in Terminal.

Bearbeiten

3. Schritt

You can now safely power down your Mac and remove the bottom case, without it accidentally powering on.

You can now safely power down your Mac and remove the bottom case, without it accidentally powering on.
Remember, you must still disconnect the battery before servicing internal components.

Bearbeiten

4. Schritt

When your repair is complete and your Mac is successfully reassembled, you can re-enable the Auto Boot feature.

When your repair is complete and your Mac is successfully reassembled, you can re-enable the Auto Boot feature.
- Power on your Mac and launch Terminal.
- Copy and paste the following command (or type it exactly) into Terminal:
  - sudo nvram AutoBoot=%03
- Press [return].
- If you are prompted for an administrative password, type the password and press [return].
  - Your password will not be displayed in Terminal.
Alternatively, you may reset your Mac's NVRAM to re-enable Auto Boot.