Diese Übersetzung enthält möglicherweise noch nicht die neuesten Änderungen der Original-Anleitung. Hilf mit, die Übersetzung zu aktualisieren oder sieh dir die Original-Anleitung an.
Einleitung
Grundständige Anleitung zum Austausch der 2.5 Zoll Festplatte.
Was du brauchst
-
-
Entferne die 4 6.5mm T9 Schrauben (2 auf jeder Seite) die die Festplatte in der Halterung festhalten.
-
-
Arbeite die Schritte in umgekehrter Reihenfolge ab, um dein Gerät wieder zusammenzubauen.
Arbeite die Schritte in umgekehrter Reihenfolge ab, um dein Gerät wieder zusammenzubauen.
Rückgängig: Ich habe diese Anleitung nicht absolviert.
4 weitere Nutzer:innen haben diese Anleitung absolviert.
Besonderer Dank geht an diese Übersetzer:innen:
83%
Diese Übersetzer:innen helfen uns, die Welt zu reparieren! Wie kann ich mithelfen?
Hier starten ›
Like others, a T8 screw driver worked best for me on the 4 hard drive screws.
sorinjc - Antwort
it is t8 not t9. you owe me a TR6 Torx Security bit :D
giammin - Antwort
I found the 4 screws quite hard to remove and needed to use an 8mm spanner on the back of my T8 screwdriver to get them loose.
Reiner Friedel - Antwort
Screws have loctite residue. I put a tiny drop of fresh blue (semi-permanent) on each screw before reinstalling.
Jon Scott - Antwort
T9 was the right one for mine
Bill Pennock - Antwort
T9 Torx from recommended barely allowed me to remove these screws. I had to press very strong them into screws, so that pressure and minimal adhesion made it possible to move something.
Vitalijs Ozornins - Antwort
T8 was more appropriate for me !!!
afajner - Antwort
The instructions at the top recommend a T9 but the link plops a TR9 into your basket. In any event, the T8 works better.
tom - Antwort
T8 was also good for me. Mini was manufactured in 2016 October.
soul.tan - Antwort
TR7 did the job.
Benni Piron - Antwort
Is this a security screwdriver just like the TR6 Security Screwdriver?
Shubham Ojha - Antwort
When i did the re-assembly as I was adding a drive to a pcie only mac, i didnt have any t8 screws (so used standard phllips onces which came with the sata kit but i struggled to make sure the wires were out of the way. I dont know if the configuration for mac minis with drive is slightly different but you need to be careful not to screw down any of the wires (i think for IR sensors).
Edward Chandler - Antwort
Can anyone confirm a T8S (security) driver is needed for this, not a non-security T8?
Cornfritter - Antwort