Einleitung
This guide is going to show you how to take apart the blaster to reach the spring that is located in cocking mechanism of the Nerf.
Was du brauchst
-
-
Locate the 12 Philips head screws and remove them: Head Diameter= 4.3mm, Thread Pitch= 1mm, Screw Length= 8mm
-
-
-
Before removing the cover, make sure to first remove the cover for the cocking mechanism. The top half is freely removable.
-
-
-
-
Once the screws have been removed, lift the top half of the gun off.
-
Take care and try not to lose any smaller pieces as you open it up.
-
Locking tab for attachments.
what is a locking tab? and where do i see it? sorry my english is bad
its the front sight post
-
-
-
Remove the screw on the inside of the gun.
-
Screw specifications: Philips head, Head Diameter= 4.3mm, Thread Pitch= 1mm, Screw Length= 8mm
-
-
-
Remove the barrel from the blaster.
-
Remove the front component from the blaster.
-
Both components do not need any tools to be removed.
-
-
-
First, remove the trigger.
-
Then remove the cocking holdback.
-
Then remove the air compressor chamber.
-
-
-
Locate and remove the indicated screw.
-
This is the spring controlling the cocking mechanism. If the spring is damaged, replace it.
Where do I buy a new one
hi my spring is broken to and i was wondering where to buy a replacement spring for this nerf blaster
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Rückgängig: Ich habe diese Anleitung nicht absolviert.
17 weitere Personen haben diese Anleitung absolviert.
Team
USF Tampa, Team 5-4, Blackwell Fall 2015 Mitglied von USF Tampa, Team 5-4, Blackwell Fall 2015
USFT-BLACKWELL-F15S5G4
4 Mitglieder
13 Anleitungen geschrieben
21 Kommentare
Where does the locking tab in step 5 go
on the top of the gun(Seeing from the position as if you're aiming)
Its only there for accesory so it still works if you don't return it
chanisco -
What type of spring is it and where can I buy it because I stretched it too much and now it won't work
Me too, someone please answer this!
Where did the little, orange rectangle that appears in Step 5 come from and where do I put it back??
Ooops, okay, got it. I just saw the message above on this same topic!
Where could I get a replacement for the spring that pulls the cocking mechanism back?
Please any links or information on the replacement springs? You can’t complete this fix without new springs….
So I had the same problem I fixed the gun without the return spring. It isn’t worth Jack. I found with a side by side comparison of the disruptor and Strongarm that on the catch the disruptor has a better spring which fits on an internal notch. On the Strongarm you have to compress the catch spring a bit to fit it in.
The piece of plastic that hoocks on to the plunger brock off so I cant find a spare part
What should I do?
Where can i buy a replacement spring for the priming handle on a disruptor
mine will slam fire, but not single fire. any tips?
I have cocking holder parts
