Einleitung

This guide will show you the steps on installing the motherboard. This will be helpful if the controller won't turn on or if it turns on and doesn't work.

Ersatzteile

Kein Ersatzteil erforderlich.

Pull down on the battery cover release lever and pull back to remove the cover. Pull down on the battery cover release lever and pull back to remove the cover.
  • Pull down on the battery cover release lever and pull back to remove the cover.

Kommentar hinzufügen

Take out each battery then put the covering back on.
  • Take out each battery then put the covering back on.

Kommentar hinzufügen

Remove the eight 9-mm Tri-Wing screws on the back panel with the Tri-wing Y1 screwdriver. During reassembly, firmly hold the panels of the controller together while replacing screws so the panels don't separate.
  • Remove the eight 9-mm Tri-Wing screws on the back panel with the Tri-wing Y1 screwdriver.

  • During reassembly, firmly hold the panels of the controller together while replacing screws so the panels don't separate.

Kommentar hinzufügen

After each screws has been removed carefully turn over the controller, and place on a flat surface. Slowly separate the top panel from the bottom panel.
  • After each screws has been removed carefully turn over the controller, and place on a flat surface.

  • Slowly separate the top panel from the bottom panel.

  • The buttons are loose and may fall off of the motherboard.

  • Once seperarted set aside the top panel.

  • During reassembly, make sure the front panel lines up with the buttons so they slide back into place.

Kommentar hinzufügen

Use tweezers to remove the buttons. It may be easier to remove the A button off of the pad by lifting it with your fingers. During reassembly, make sure all buttons are in their respective sockets so they match up with the front panel.
  • Use tweezers to remove the buttons.

  • It may be easier to remove the A button off of the pad by lifting it with your fingers.

  • During reassembly, make sure all buttons are in their respective sockets so they match up with the front panel.

Kommentar hinzufügen

Using tweezers remove the three grey button pads from the motherboard.
  • Using tweezers remove the three grey button pads from the motherboard.

Kommentar hinzufügen

With your fingers gently grip the motherboard on both sides and lift it away from the back panel.
  • With your fingers gently grip the motherboard on both sides and lift it away from the back panel.

  • To put the motherboard back into place, align the two metal clips under the motherboard with the slots in the back panel. The motherboard should fall into place.

Kommentar hinzufügen

Abschluss

To reassemble your device, follow these instructions in reverse order.

5 weitere Nutzer haben diese Anleitung absolviert.

Travis Taylor

Mitglied seit 12.04.2013

242 Reputation

5 Anleitungen geschrieben

Team

Cal Poly, Team 10-40, Amido Spring 2013 Mitglied von Cal Poly, Team 10-40, Amido Spring 2013

CPSU-AMIDO-S13S10G40

4 Mitglieder

15 Anleitungen geschrieben

Kommentar hinzufügen

Statistik anzeigen:

Letzte 24 Stunden: 3

Letzte 7 Tage: 8

Letzte 30 Tage: 49

Insgesamt: 3,596