Zum Hauptinhalt wechseln

Diese Übersetzung enthält möglicherweise noch nicht die neuesten Änderungen der Original-Anleitung. Hilf mit, die Übersetzung zu aktualisieren oder sieh dir die Original-Anleitung an.

iPod Shuffle 3. Generation Akku wechseln

Was du brauchst

  1. Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!

    iPod Shuffle 3. Generation Akku wechseln: Schritt 1, Bild 1 von 1
    • Widen the small gap between the front and rear case by inserting a metal spudger into the gap near the top of the iPod.

    • Be careful when using a metal spudger, as you may scratch the outer case.

  2. Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!

    iPod Shuffle 3. Generation Akku wechseln: Schritt 2, Bild 1 von 2 iPod Shuffle 3. Generation Akku wechseln: Schritt 2, Bild 2 von 2
    • Insert an iPod opening tool into the newly widened gap, and pry the rear case up and away from the front case.

  3. Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!

    iPod Shuffle 3. Generation Akku wechseln: Schritt 3, Bild 1 von 1
    • Insert the iPod Shuffle opening tool into the gap between the front and rear case on the same side, at the bottom corner of the iPod.

    • Pry the rear case away from the front case.

  4. Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!

    iPod Shuffle 3. Generation Akku wechseln: Schritt 4, Bild 1 von 1
    • Lift the bottom of the rear case and remove it from the rest of the iPod.

  5. Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!

    iPod Shuffle 3. Generation Akku wechseln: Schritt 5, Bild 1 von 1
    • Disconnect the headphone jack and shuffle switch connector by prying it off the logic board with a spudger.

  6. Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!

    iPod Shuffle 3. Generation Akku wechseln: Schritt 6, Bild 1 von 1
    • Remove the single Phillips screw securing the logic board to the front case.

  7. Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!

    iPod Shuffle 3. Generation Akku wechseln: Schritt 7, Bild 1 von 1
    • Peel the battery up from the front case with an iPod opening tool.

    • Remove the logic board and battery from the iPod.

  8. iPod Shuffle 3. Generation Akku wechseln, Akku: Schritt 8, Bild 1 von 1
    • Die Batterie des iPods ist mit Lötkontakten zur Platine verbunden. Jetzt müssen Sie die Lötkontakte erhitzen mit einem Lötkolben

    • Hier Übersetzung einfügen

    • Hier Übersetzung einfügen

    • Hier Übersetzung einfügen

  9. Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!

    iPod Shuffle 3. Generation Akku wechseln: Schritt 9, Bild 1 von 1
    • Repeat the previous step for the remaining solder pad.

    • Once the two connections have been desoldered, lift the old battery off the logic board.

    • For tips on soldering a new battery to the logic board, follow the repairing soldered connections guide.

Abschluss

Um dein Gerät wieder zusammenzubauen, folge den Schritten dieser Anleitung in umgekehrter Reihenfolge.

6 weitere Nutzer:innen haben diese Anleitung absolviert.

Besonderer Dank geht an diese Übersetzer:innen:

en de

83%

Diese Übersetzer:innen helfen uns, die Welt zu reparieren! Wie kann ich mithelfen?
Hier starten ›

Matthew Newsom

Mitglied seit: 01/05/10

39.524 Reputation

67 Anleitungen geschrieben

7 Kommentare

IS THIS DONE ANYWHERE IN cHENNAI-mADRAS sOUTH iNDIA PL INFORM.

Kumaraswami Vallur Sundaresan - Antwort

Is this done anywhere in Chennai- Madras South India?

Kumaraswami Vallur Sundaresan - Antwort

Thanks, it’s very helpful.

taiotp - Antwort

Im going to try and replace the battery with a 3rd party battery and was wondering if you knew which side was the positive and negative

Kai Nodera - Antwort

Hi where have u got the battery from

Rishii k -

Kommentar hinzufügen

Seitenaufrufe:

Letzte 24 Stunden: 11

Letzte 7 Tage: 60

Letzte 30 Tage: 264

Insgesamt: 57,719