Einleitung

prerequisite

  1. Use the tip of a spudger to peel back a small piece of tape covering a screw on the side of the headphone jack.
    • Use the tip of a spudger to peel back a small piece of tape covering a screw on the side of the headphone jack.

  2. Remove the following screws securing the headphone jack, Lightning connector, and speaker.
    • Remove the following screws securing the headphone jack, Lightning connector, and speaker.

    • Three 2.6 mm #000 Phillips screws

    • Two 2.0 mm #000 Phillips screws

  3. Kostenloser Versand für alle Bestellungen über 100 $ oder mit einem Pro Tech Toolkit!

    Schau dich im Store um
  4. Use the flat end of a spudger to pry the speaker up from the rear case.
    • Use the flat end of a spudger to pry the speaker up from the rear case.

    • Do not try to remove the speaker, as it is soldered to the Lightning connector assembly.

  5. Grasping the large ribbon cable, gently pull the Lightning connector assembly out of the bottom of the case. Grasping the large ribbon cable, gently pull the Lightning connector assembly out of the bottom of the case.
    • Grasping the large ribbon cable, gently pull the Lightning connector assembly out of the bottom of the case.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Andrew Optimus Goldberg

Mitglied seit: 17.10.2009

408.935 Reputation

412 Anleitungen geschrieben

Team

iFixit Mitglied von iFixit

Community

108 Mitglieder

8.294 Anleitungen geschrieben

Kommentar hinzufügen

Statistik anzeigen:

Letzte 24 Stunden: 0

Letzte 7 Tage: 0

Letzte 30 Tage: 3

Insgesamt: 110