Zum Hauptinhalt wechseln

Modell A1311 / Mitte 2011 / 2.5 & 2.7 GHz Core i5 oder 2.8 GHz Core i7 Prozessor

432 Fragen Alle anzeigen

PSU power on signal

I’m trying to to use the iMacs PSU to build a mini-itx hackintosh.

Is it possible to use the power-on button in the iMac and then somehow connect it to the PSUs pin12, which should be the power-on signal?

PSU pin-out: Power Supply (PSU) pin-out diagram

I have removed the main board to make room for a display converter board to use the screen as a monitor, so I need to connect the power-on button directly to the PSU if possible.

Diese Frage beantworten Ich habe das gleiche Problem

Ist dies eine gute Frage?

Bewertung 0
Einen Kommentar hinzufügen

1 Antwort

Are you using the Apple power supply or the one that came with your conversion kit?

You will need to emulate the circuit Apple uses on the logic board which feeds the Apple power supply the power on signal. Remember this is a soft power button, it is a momentary switch driving a signal line low (chassis ground).

War diese Antwort hilfreich?

Bewertung 0

2 Kommentare:

Hi Dan

Thanks.

I want to use the Apple power supply for the entire Mini-ITX build. Currently, I’m using an external power brick to power the screen, but if I can get the Apple PSU to power up I want to switch to it.

Yes, I figured its a soft power button. Question is:

Does the PSU power up if I just connect Pin 12 to ground?

IF this works, how can I then turn the soft power button signal into a permanent signal for the PSU to remain on?

Does the PSU require any load like a normal ATX PSU, where a small 10-20W resistor can be applied to the 5v rail to emulate the motherboard (seen here: https://www.electronics-tutorials.ws/blo...)

von

You'll need to experiment!

I have not dug that deep into the circuit and its not documented any where.

von

Einen Kommentar hinzufügen

Antwort hinzufügen

Justice wird auf ewig dankbar sein.
Seitenaufrufe:

Letzte 24 Stunden: 2

Letzte 7 Tage: 8

Letzte 30 Tage: 12

Insgesamt: 99