DYMO® DYMO® LabelManager 280

1 2 3 4 5 6 7 8 9 0 Q W E R T Y U I O P A S D F G H J K L ..# Z X C V B N M A++3

Quick Reference Guide

LabelManager $ ^{\textregistered} $ 280

Copyright

© 2012 Sanford, L.P. All rights reserved.

No part of this document or the software may be reproduced or transmitted in any form or by any means or translated into another language without the prior written consent of Sanford, L.P.

Trademarks

DYMO, DYMO Label, and LabelManager are registered marks in the US and other countries. All other trademarks are the property of their respective holders.

Quick Reference Guide

This guide describes some of the features of your DYMO $ ^{\circledR} $ LabelManager $ ^{\circledR} $ 280 label maker. Read the following sections for information about using your label maker.

Registering Your Label Maker

Connecting the Power

Inserting the Label Cassette

Getting to Know Your Label Maker

Installing DYMO Label Software

Connecting the Label Maker to Your Computer

Using DYMO Label Software

PDF

For complete information on using your label maker, download the full LabelManager 280 User Guide at http://userguides.dymo.com.

Registering Your Label Maker

Visit www.dymo.com/register to register your label maker online. During the registration process, you will need the serial number, which is located inside the back cover of the label maker.

Register your label maker to receive these benefits:

Notification of software upgrades by email

Special offers and new product announcements

Connecting the Power

The label maker is powered by a rechargeable, lithium-ion (Li-ion) battery pack.

Inserting the Battery

The battery pack included with your label maker comes partially charged.

Make sure the charging adapter is disconnected before handling the Li-ion battery pack.

To insert the battery

1 Slide the battery compartment cover away from the label maker. See Figure 1.

2 Insert the battery into the battery compartment as shown in Figure 1.

Figure 1

3 Replace the battery cover.

Figure 1

△！

Make sure to read the Li-ion Safety Precautions found on "Safety Precautions

for Lithium-ion Rechargeable Battery Pack" on page 8.

Removing the Battery

Remove the battery pack if the label maker will not be used for a long period of time.

Make sure the charging adapter is disconnected before handling the Li-ion battery pack.

To remove the battery

1 Unplug the charging adapter.

2 Slide the battery compartment cover away from the label maker. See Figure 1.

3 Remove the battery from the battery compartment.

Make sure to read the Li-ion Safety Precautions found on page 8.

Charging the Battery

A charging adapter is included with your label maker for recharging the battery pack. Charging the battery pack will take approximately three hours; however, after charging for about 10 minutes, the label maker can be used to print labels.

The charging adapter is only used for recharging the battery pack; the charging adapter cannot be used to power the label maker.

Figure 2

To recharge the battery

Figure 2

1 Plug the charging adapter into the power connector on the top of the label maker. See Figure 2.

2 Plug the other end of the charging adapter into a power outlet.

Make sure to read the Li-ion Safety Precautions found on page 8.

Inserting the Label Cassette

Your label maker uses DYMO D1 label cassettes.