Rack mount tray installation

Introduction

This document describes how to install the HP Z200 and Z210, Z400, and xw4000 series Workstations into a rack mount tray. It also describes how to mount the workstation-tray assembly into a rack.

Kit contents

Rack mount tray

Adapter brackets

• Rails and mounting hardware (installation instructions in Appendix A of this document)

Installation instructions

Warranty information

Required tools

T-15 Torx screwdriver

T-20 Torx screwdriver

Cross-tip screwdriver

☐ ☐ ☐ ☐

601530-002

© 2011 Hewlett-Packard Development Company, L.P. Printed in the U.S.

Warnings and cautions

WARNING! Any surface or area of the equipment marked with this symbol indicates the presence of an electrical shock hazard. To reduce the risk of injury from electrical shock, do not open any enclosed area marked with this symbol.

WARNING! To reduce the risk of electric shock or damage to your equipment:

— Do not disable the power cord grounding plug. The grounding plug is an important safety feature.

— Plug the power cord in a grounded (earthed) outlet that is easily accessible at all times.

— Disconnect power from the equipment by unplugging the power cord from the electrical outlet.

WARNING! Any surface or area of the equipment marked with this symbol indicates the presence of a hot surface or hot component. If this surface is contacted, the potential for injury exists. To reduce the risk of injury from a hot component, enable the surface to cool before touching.

WARNING! If a product is shipped in packaging marked with this symbol, the product must always be lifted by two persons to avoid personal injury due to product weight.

WARNING! To reduce the risk of serious injury, read the Safety and Comfort Guide. It describes proper workstation setup, posture, health, and work habits for computer users, and provides important electrical and mechanical safety information. This guide is located at http://www.hp.com/ergo and on the documentation CD (if one is included with the product).

CAUTION: Static electricity can damage the electronic components of the workstation. Before beginning these procedures, be sure you discharge static electricity by briefly touching a grounded metal object.

CAUTION: To prevent damage to the workstation, observe the following Electrostatic Discharge (ESD) precautions while performing the system parts removal and replacement procedures:

— Work on a static-free mat.

— Wear a static strap to ensure that any accumulated electrostatic charge is discharged from your body to the ground.

— Create a common ground for the equipment you are working on by connecting the static-free mat, static strap, and peripheral units to that piece of equipment.

NOTE: HP accessories are for use in HP Workstation products. They have been extensively tested for reliability and are manufactured to high quality standards.

Step 1—Preparing the workstation

NOTE: All illustrations are examples only. Workstation models vary. For product-specific information, see the service guide for your HP workstation at http://www.hp.com/support/manuals before beginning installation.

To prepare the workstation for component installation:

1. Power down the workstation, and then disconnect the power cord.

2. Power down all external devices, and then disconnect them from the workstation.

Step 2—Mounting the rails to the rack

1. Attach the rails to the rack. See Appendix A for installation instructions.

2. If glide strips were not factory-installed, then apply them to the rail shelf.

a. Remove the adhesive backing from the back of the glide strips.

b. Apply a glide strip to the top surface of each rail.

Figure 1 Applying glide strips

1

Step 3—Attaching the rack mount tray to the workstation

1. Using a T-15 Torx screwdriver, remove the indicated chassis screw (1), if present, from the rear of the workstation. Some workstation models do not use the chassis screw as shown.

Figure 2 Removing the chassis screws

1

2. To prepare the tray:

a. Select the adapter bracket with the label that matches