Last modified: 08/02/2022 01:34:27

Cup Holder (Remove and Replace)

Correction code 15191802

FRT 0.35

NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.

NOTE: See to learn more about FRTs and how they are created. To provide feedback on FRT values, email . Make sure to wear proper PPE when performing below procedure. Flat Rate Times LaborTimeFeedback@tesla.com

Correction Codes and FRTs

• Model Y for Cup Holder (Remove and Replace): 15191802, 0.35
• Model Y for Cup Holder (2nd Generation) (Remove and Replace): 15191812

NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See to learn more about FRTs and how they are created. To provide feedback on FRT values, email . Make sure to wear proper PPE when performing below procedure. Flat Rate Times LaborTimeFeedback@tesla.com

Torque Specifications

Table 1. Torque Specifications: Cup Holder (Remove and Replace)

Table Caption: Table 1 lists the torque specifications, recommended tools, and reuse/replacement guidelines for screws involved in removing and replacing a cup holder assembly. It details specific torque values for screws attaching the lower assembly to the center console and for the screw connecting the armrest latch grommet to the cup holder.

Remove Cup Holder for Original Center Console

• Disconnect 12V power. See . 12V/LV Power (Disconnect and Connect)

• Remove the LH and RH center console bright strips. See . Bright Strip - Center Console - LH (Remove and Replace)

• Remove the center console cup holder decor trim. See . Decor Trim - Cup Holder - Center Console (Remove and Replace)

• Use a plastic trim tool to remove the cup holder liner from the cup holder.

• Disconnect the electrical harness from the center console power socket connector.

• Disconnect the electrical harness from the center console puddle light connector.

• Remove the screws that attach the cup holder lower assembly to the center console, and remove the cup holder from the vehicle.

Torque 1.1 Nm

Tip: Use of the following tool(s) is recommended:

• Torx T20 socket

• 4 in extension

• Release the small tabs on the spring cap and slide the power socket inside the cap, so that the openings in the side of the socket align with the large tabs of the cap.

• Release the tabs of the cap and move the power socket and cap together out through the cup holder assembly.