Step 1

Unpack Contents

Unpack your scanner package and check for major components.

2. USB cable

3. ScanMaker i800 Plus

4. Power adapter

5. Software CDs/DVDs

6. Power cord

7. EZ-Lock™ Film Holders

2 3

Step 2

Important: Do not remove the yellow stickers from your scanner until you are told to do so. You must install software before connecting your scanner.

Install Software

Always close any open programs, and turn off Anti-virus utilities before installing software.

PC:

A. Place the Adobe DVD into a drive, and install the software. Skip this step if you have a newer version of Photoshop Elements already installed on your computer.

B. Place the Microtek Software CD/DVD into a drive, and follow the on-screen instructions to install the driver and software.

C. Insert the IT8 Calibration Data CD for the Microtek Scanner ICC Profiler (MSP) program into your CD/DVD-ROM drive, and follow the on-screen instructions for installation.

D. Restart your computer at the end of all software installation.

O

MAC:

A. Place the Adobe DVD into a drive, and install the software. Skip this step if you have a newer version of Photoshop Elements already installed on your computer.

B. Place the Microtek Software CD/DVD into a drive, and double-click the ScanWizard Pro installer icon to install ScanWizard Pro first. Next, double-click the MSP installer icon to install the Microtek Scanner ICC Profiler (MSP) program. Finally, insert the IT8 Calibration Data CD, and double-click the IT8 installer icon to complete MSP installation.

C. Install the remaining software components, then restart your computer at the end of all software installation.

NOTE: After rebooting your Macintosh, the Microtek software will attempt to locate your scanner on the system. Since this is your first install and you have not yet connected the scanner, simply ignore the message that appears and proceed to the next step.

Step 3

Unlock Scanner

A. Remove the yellow "Step 3" sticker from your scanner.

B. With the scanner power off, tilt the back left corner of the scanner to see the locking switch at the bottom.

C. Push the locking switch to the position (as indicated by the graphic on the right), with the icon on the lock showing as “unlocked”.

NOTE: To lock the scanner (for shipping and other reasons), refer to the ScanMaker i800 Plus Supplement.

D. Raise the scanner lid (TMA), and look for the locking switch at the base of the TMA.

E. Push the locking switch to the position (as indicated by the graphic on the right), with the icon on the lock showing as “unlocked”.

Locked Unlocked

Step 4

Connect Scanner

To the