Dell PowerEdge R310 Getting Started Guide
DeII™ PowerEdge™ R310 Systems
Getting Started With Your System
Guide de mise en route
Primeiros passos com o sistema
Procedimientos iniciales con el sistema
DELL™
DeII™ PowerEdge™
R310 Systems
Getting Started
With Your System
Regulatory Model: E07S Series Regulatory Type: E07S002
DELL™
Notes, Cautions, and Warnings
NOTE: A NOTE indicates important information that helps you make better use of your computer.
△ CAUTION: A CAUTION indicates potential damage to hardware or loss of data if instructions are not followed.
WARNING: A WARNING indicates a potential for property damage, personal injury, or death.
January 2010 P/N K086K Rev. A00
Installation and Configuration
△！
WARNING: Before performing the following procedure, review the safety instructions that came with the system.
Unpacking the System
Unpack your system and identify each item.
Installing the Rails and System in a Rack
Assemble the rails and install the system in the rack following the safety instructions and the rack installation instructions provided with your system.
Optional – Connecting the Keyboard, Mouse, and Monitor
Connect the keyboard, mouse, and monitor (optional).
The connectors on the back of your system have icons indicating which cable to plug into each connector. Be sure to tighten the screws (if any) on the monitor's cable connector.
Connecting the Power Cable(s)
Connect the system's power cable(s) to the system and, if a monitor is used, connect the monitor's power cable to the monitor.
Securing the Power Cables
ピンクのコーヒー
Bend the system power cables into a loop as shown in the illustration and secure the cables to the brackets using the provided strap. Plug the other end of the power cables into a grounded electrical outlet or a separate power source such as an uninterrupted power supply (UPS) or a power distribution unit (PDU).
Turning On the System
Press the power button on the system and on the optional monitor if used. The power indicators should light.
Installing the Optional Bezel
$ \uparrow $
Install the bezel (optional).
