Last modified: 20/12/2021 09:07:48
Cover - Penthouse (Remove and Replace)
Correction code 16101002
FRT 0.90
NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.
NOTE: See to learn more about FRTs and how they are created. To provide feedback on FRT values, email . Make sure to wear proper PPE when performing below procedure. Flat Rate Times LaborTimeFeedback@tesla.com
- 1127845-00-A Asy, Service Cover, Penthouse, Model 3
- 1059330-00-B Skt, 1/4in Dr, 5-Lobe Torx Plus External
- 1076971-02-A Wrench, Torque + Angle, 1/4" Dr
- 1108272-00-B Cap, Logic Conn, Inv, 3DU
Warning
Remove all jewelry (watches, bracelets, rings, necklaces, earrings, ID tags, piercings, etc.) from your person, and all objects (keys, coins, pens, pencils, tools, fasteners, etc.) from your
pockets before performing any procedure that exposes you to high voltage.
Warning
If corrective eyewear is necessary to safely perform any procedure, make sure that the eyewear is securely restrained to the head and cannot fall off.
Warning
Only technicians who have been trained in High Voltage Awareness and have completed all required certification courses (if applicable) are permitted to perform this procedure. Proper personal protective equipment (PPE) and insulating HV gloves with a minimum rating of class 0 (1000V) must be worn at all times a high voltage cable, busbar, or fitting is handled. Refer to Tech Note TN-15-92-003, 'High Voltage Awareness Care Points' for additional safety information.
Torque Specifications
Table 1. Torque Specifications: Cover - Penthouse (Remove and Replace)
| Description | Torque Value | Recommended Tools | Reuse/Replace | Notes |
|---|---|---|---|---|
| Nut that attaches the positive 12V output cable to the DCDC passthrough | Torque 15 Nm | 13 mm12-point deep socket 3 in extension Ratchet/torque wrench | Replace | Note Mark the fastener with a paint pen after torquing. |
Table Caption: This table provides torque specifications for a Penthouse cover, detailing the nut that attaches the positive 12V output cable to the DCDC passthrough, requiring a torque of 15 Nm and replacement after use. Recommended tools include a 13 mm 12-point deep socket, a 3-inch extension, and a ratchet/torque wrench, with a note to mark the fastener after torquing.
| Description | Torque Value | Recommended Tools | Reuse/Replace | Notes |
|---|---|---|---|---|
| Bolt that attaches the penthouse cover to the high voltage controller | Torque Gasketless Bolts 5 Nm +30 deg | External Torx E10 4 in extension Ratchet/torque wrench Torque wrench with angle measurement | Replace |
Table Caption: This table provides specifications for the bolt attaching the penthouse cover to the high voltage controller, detailing torque values, recommended tools, and guidelines for reuse or replacement.
**Table Caption: This table provides torque specifications, recommended tools, and reuse guidelines for a bolt
