Luis Vitorio Cargnini

So they are using magnetic actuators to create the force haptic feedback effect on the joysticks (Foster)?

How can’t I just plug an m.2 SSD and start using it? “(once enabled by Sony) “

How is that of software optical drive activated?

@corytc and @tomchak I did replace the module, in general, you buy (Amazon or eBay) you will receive a module of 6 modules you need a multimeter and test each module interface, measure both resistances and subtract them, the one nearest zero is the module you will use since is the one with least drift from the factory.

Just disassemble it, turn upside down uses a solder remover and unsolder the old one, place the new one solder back, boom you are done.

Like you will need an iron solder with medium and thin tips, I used lead-free solder, so is a patience test, be careful with the wires from the rumbles, try not to unsolder them since is a thin wire and is difficult, like I have big hands so took me a while to solder back.

Just contact Hasbro/Hotwheels to replace it, in my case there was oxidation on the controllers, once they replaced, all worked fine, but go straight to Hasbro.

Give the part numbers so we can source the circuits and change the devices if needed. Also can anyone extract the rim? I believe the rim being used is way low quality.

I can't make to the “adjust steering” section no matter what does anyone have any idea how can I get into it ?

It only allows me:

-speaker volume

-engine sound

Thou no adjust steering, and when o start the car holding settings it goes.into sensor reading only

Yes, MAC is associate dand it is unique with each Network interface: wireless or wired.