John Savio

Hi all, I have an ipod touch 4th gen 16gb on which I did a lcd replacement. I have done this a lot of times but never...

Hi, I would suggest use an app to control your fans, so that they spin a bit more faster which in turn will keep the temps down. I would suggest try using this app and see how it works. You could also try and re-apply your cpu compound which will help as well to reduce the temps. https://www.crystalidea.com/macs-fan-control Hope this will solve your issue.

Hi, have you tried pressing the home and power button together for about 10 secs and then pressing the power button to power it up again? If that still does not work, check if the cable is seated properly. Still no luck, then u might have damaged the flex cable when u installed the screen. Write back on what u did. Good luck.

Hi, Do u have a dvd drive also connected. You need to open your computer and look for the cables that connect the hard disk and dvd drive to the motherboard. Try using different sata ports. If still it does not work, try plugging them one at a time. Hope this helps. Write back on what u did. Good luck.

Just follow this guide. Nintendo 3DS SD Kartenleser austauschen

Hi, you cannot upgrade the GT9400m as it is soldered to the logic board. Check the link below. Hope this helped. http://forums.macrumors.com/showthread.p...

Hi, if u have a bad or corrupted memory card try coping the files to ur computer and then format the card using the psp. Then try putting the files back and check if u can access them. Write back on what u did. Good luck.

Hi, it might be that the cables are faulty. Can u see the xbox showing the green rings? An hdmi cable is not that costly now, so see if u can get one and test with hdmi. Write back on what u did. Good luck.

First thing u need to do is clean the motherboard using isopropyl alcohol. Use a small brush to clean all the parts. Only after that should u consider any other option and one more thing, solder melts at 183 degree centigrade and the non lead solder melts at 217 degree centigrade. Also to the reflow be successful u need to use liquid flux. But clean first. Write back on what u did. good luck.

Hi, most probably it is an issue with the power supply unit. Do u have access to another power supply unit, like one from a friend? Plug that in and see if that works ok. If that is ok then u would want to replace the psu. Did this happen after an intense session of gaming? Write back on what u did. Thanks.

Hi, u need to route the cables underneath to the wifi card. There is picture of the wifi card in step 5. There should be two arrows on the card near the connector points. One black and the other one white. The black cable goes to the black connector and the white cable to the white connector. Hope this helps. Write back on what u did. Good luck.