daniel

Has anyone found a fix for ghd platinum red light and beep yet

This laptop won't turn on after a power cut. When the charger is plugged in the power brick light goes out. I felt a mosfet g...

@refectio i have an issue with this iphone 6. when i got it, it wouldnt boot. on dc and charger with battery disconnected it ...

so i have an s6 edge+ no power, replaced both power ic’s. getting around 3.5v in both locations but not turning on and no ima...

so i have an iphone 7 in this morning and as title says i have a vdd main short, wire soldered on and drawing 2 amps but no s...

i have a macbook air 820-3437 which was liquid damaged, doa. corrosion was around smc and u7700, reballed smc and it turned o...

does anyone have an apple gsx account that can help me figure out how to get an account

i have a ps4 that wont boot when the power button is pressed just blue pulsing light, yet it will boot into safe mode and boo...

im having an issue with an iphone 6, when i got it, it was bootlooping, now i have replaced pmic, tristar and tigris. but doe...

@refectio i bought a liquid damaged se the other day and recieved it this morning. on dc its drawing over half an amp which i...

Check the port for dust or fluff.

i seen this on another page. Just fixed MacBook Pro stuck in Sleep and Fans running high. All you need to do is open up case and unplug the fans from motherboard! Somehow the temperature sensing must be in fan air and it senses high temp and shuts down computer with fans on high. Some how restarting computer doesn't reset things (design fault or firmware bug). But UNPLUG FANS and you're good to go. I did this while powered on and it sprang into life! Later I checked it powers down and reboots. Don't forget to plug fans in again before completion and fans "hey presto" run at normal speed. Apple engineers couldnt fix this and said we had to buy new board or computer $2k+. Good luck

Run a jumper wire from the gold pad you circled in blue. Then put a drop of uv solder mask over it.

Try using 3utool to kick it out of recovery.

Have you looked around the touch ic.

Ifixit doesn't do repairs it's only a help forum.

It sounds like the pins of the charging port have ripped pads on the charge port circuit

iPhone 5 marked in red

The 1 to the left is a capacitor c355 the other is a filter fl49 the filter would be the important 1.

I assume it's an iPhone but which model as there is a few models that have issues with the touch ic. Could also be that he received a bad batch of lcds. Try a different shop and get a genuine screen