Zum Hauptinhalt wechseln

Herausgegeben am 25. September 2015. Model A1687/A1634. Die Reparatur des 6s Plus gestaltet sich ähnlich zu denen früherer Generationen; benötigt werden Schraubenzieher und Hebelwerkzeuge. Verfügbar mit GSM oder CDMA / 16, 64 oder 128 GB / Silber, Gold, Space Grau oder Roségold.

1042 Fragen Alle anzeigen

I replaced my battery and now my phone is stuck on a boot loop

I replaced my iPhone battery with parts bought of Ifixit and as soon as I plugged my battery in my phone was constantly stuck in a boot loop. I restored the phone completely from iTunes and the phone is still in a boot loop and now it has a load bar at the bottom. Once it loads the phone reboots again.

Beantwortet! Antwort anzeigen Ich habe das gleiche Problem

Ist dies eine gute Frage?

Bewertung 1
2 Kommentare

Did you restore phone from DFU mode? Not logo of cable asking for itunes but screen black.

von

Yeah I tried to and once I did it was still stuck in the boot loop except there was a load bar at the below the a logo.

von

Einen Kommentar hinzufügen

3 Antworten

Gewählte Lösung

Update!

Went to sell the phone and the owner of the shop figured out that for some reason the ft camera/speaker was causing the boot loop. It was original part from apple. Any reason why

War diese Antwort hilfreich?

Bewertung 2

2 Kommentare:

if the device was doing a system diagnostic, and the part was failing, the device could easily be kicked into a bootloop. a bootloop is apples protective protocal if it notices any failures. likely there was a physical corruption in it that caused the apple software to disallow booting to prevent any further damage.

von

I already tried cleaning out the speaker it isn't working

von

Einen Kommentar hinzufügen
Hilfreichste Antwort

It is possible that the battery is causing this issue but it's not a typical problem. You could try to put the old battery back to see if that helps or not.

However, I'm more concerned about possible collateral damage that may have happened during the repair. Take a look at this guide and retrace your steps to insure you did everything properly. Of particular concern is Step 16. You have to insure that the proper screws are place in the proper holes, otherwise you can damage the logic board. It's also important not to over tighten them.

You should also closely inspect the flexes and connectors to see if they are damaged.

War diese Antwort hilfreich?

Bewertung 3

7 Kommentare:

the boot loop started as soon as I plugged the battery in. All the screws are in the right place

von

Have you tried the old battery?

von

I can’t the old battery was degraded to the point that it wouldn’t be on unless it was plugged in. I have an old iPhone 6 I could use parts out of. My battery issues started up not long after my iPhone screen was replaced by a OEM screen at a shop. I was told it was original but I fear that it’s possibly I well made 3rd party part that was over drawing power.

von

Sounds like a defective battery, I would contact iFixit for a replacement.

Especially if Apple logo goes off immediately from unplugging charging cable.

von

that’s the old Apple battery

von

2 weitere Kommentare anzeigen

Einen Kommentar hinzufügen

I forgot which screws go where so what should i do

War diese Antwort hilfreich?

Bewertung 0
Einen Kommentar hinzufügen

Antwort hinzufügen

Matthew Johnson wird auf ewig dankbar sein.
Seitenaufrufe:

Letzte 24 Stunden: 4

Letzte 7 Tage: 10

Letzte 30 Tage: 41

Insgesamt: 13,639