Samsung Galaxy M51 Back Cover Replacement

Einleitung

Use this guide to remove or replace the back cover on your Galaxy M51.

You’ll need replacement adhesive to reattach components when reassembling the device.

Was du brauchst

Schritt 1 Heat an iOpener

Samsung Galaxy M51 Back Cover Replacement, Heat an iOpener: Schritt 1, Bild 1 von 1

Before beginning this procedure, completely power off your phone.
Prepare an iOpener and apply it to the back cover for at least two minutes.
A hair dryer, heat gun, or hot plate may also be used, but be careful not to overheat the phone—the display and internal battery are both susceptible to heat damage.

Übersetzen

Schritt 2 Create an opening gap

Samsung Galaxy M51 Back Cover Replacement, Create an opening gap: Schritt 2, Bild 1 von 3

Samsung Galaxy M51 Back Cover Replacement, Create an opening gap: Schritt 2, Bild 2 von 3

Samsung Galaxy M51 Back Cover Replacement, Create an opening gap: Schritt 2, Bild 3 von 3

Apply a suction handle to the back cover, as close to the USB-C port as possible.
Lift the back cover's bottom edge with your suction handle, opening a slight gap between the back cover and the frame.
Insert the tip of an opening pick in the gap you created.
Slide the opening pick to the bottom left corner and leave it there.

Übersetzen

Schritt 3 Slice through the adhesive

Samsung Galaxy M51 Back Cover Replacement, Slice through the adhesive: Schritt 3, Bild 1 von 2

Samsung Galaxy M51 Back Cover Replacement, Slice through the adhesive: Schritt 3, Bild 2 von 2

Insert a second opening pick and slide it from the bottom left corner to the bottom right corner to cut the adhesive.
Leave the opening picks in place to prevent the adhesive from resealing.

Übersetzen

Schritt 4

Insert a third opening pick under the bottom right corner of the back cover.
If you have any trouble, apply more heat to further soften the adhesive. Follow the iOpener instructions to avoid overheating.
Slide it along the right edge of the phone to the top right corner to cut the adhesive.
Leave the opening pick in the top right corner to prevent the adhesive from resealing.

Übersetzen

Schritt 5

Insert a fourth opening pick under the top right corner.
Slide it along the top edge to the left corner to cut the adhesive.
Leave the opening pick in its place to prevent the adhesive from resealing.

Übersetzen

Schritt 6

Insert a fifth opening pick on the top left corner and slide it along the edge to cut the remaining adhesive.

Übersetzen

Schritt 7 Remove the back cover

Samsung Galaxy M51 Back Cover Replacement, Remove the back cover: Schritt 7, Bild 1 von 1

Remove the back cover.

Übersetzen

Abschluss

Secure the new back cover with pre-cut adhesive or double-sided adhesive tape.

To reassemble your device, follow these instructions in reverse order. Apply new adhesive where necessary after cleaning the relevant areas with isopropyl alcohol (>90%).

Repair didn’t go as planned? Try some basic troubleshooting, or ask our Answers community for help.

2 weitere Nutzer:innen haben diese Anleitung absolviert.