Huawei MediaPad M3 Display Assembly Replacement
Einleitung
Zu Schritt 1 der AnleitungThis guide is about how to replace the Display assembly of Huawei MediaPad M3. Removing the display is a prerequisite of removing or displacing many other parts such as the front camera, the motherboard, and the rear camera. It is an 8.40 inch touchscreen with a resolution of 2560*1600 pixels at a pixel density of 359 pixels per inch. The display itself is thin and fragile; therefore all steps should be followed carefully.
Was du brauchst
-
-
Use a heat gun to heat the display. It may take up to 30 seconds.
-
Slide in the opening picks to the four corners of the tablet and peel off the display carefully.
-
-
-
Open the display carefully.
-
Use a Phillips #00 screwdriver to remove the two 3.0mm screws.
-
-
-
-
After removing the two screws, use your hand to take out the silver metal bracket.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Rückgängig: Ich habe diese Anleitung nicht absolviert.
2 weitere Personen haben diese Anleitung absolviert.
Team
Duke University Pratt School of Engineering, Team S5-G2, Matos-Garner Fall 2019 Mitglied von Duke University Pratt School of Engineering, Team S5-G2, Matos-Garner Fall 2019
DUKEPSE-MATOS-GARNER-F19S5G2
5 Mitglieder
4 Anleitungen geschrieben
