PlayStation 3 Slim Fan Replacement
Einleitung
Zu Schritt 1 der AnleitungUse this guide to replace the PlayStation 3 Slim's single cooling fan.
Was du brauchst
-
-
Turn the PS3 over and lay it on its backside.
-
Carefully peel the warranty sticker up off the lower case to reveal a hidden screw cover.
-
-
-
Use the flat end of a metal spudger to pry up the seven screw covers around the edge of the lower case.
-
-
-
Remove the seven 37 mm Phillips screws securing the top cover to the lower case.
-
-
-
Remove the four 13.3 mm T8 security Torx screws beneath the Blu-ray drive opening. (Some models may only have three screws)
-
-
-
Lift the top cover from its rear edge and rotate it toward the front of the PS3.
-
Lift the top cover off the PS3.
-
-
-
-
Squeeze the AC inlet connector's locking mechanism and pull straight up to disconnect it from the power supply.
-
-
-
Pull the DC-Out cables straight up to lift their connector up and out of its socket on the power supply.
-
-
-
Remove the two 7.6 mm Phillips screws securing the power supply to the lower case.
-
-
-
Lift the power supply upward from its left edge as viewed from the front of the PS3.
-
-
-
Continue to lift the left edge of the power supply until it lifts off the two metal posts shown in the second picture.
-
Remove the power supply from the PS3, minding any cables that may get caught.
-
-
-
Pull the fan cables upward to lift the fan connector up and out of its socket on the motherboard.
-
-
-
De-route the fan cables from under the plastic hook molded into the fan shroud.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Rückgängig: Ich habe diese Anleitung nicht absolviert.
63 weitere Personen haben diese Anleitung absolviert.
