Was du brauchst
-
-
Start off by using a Philips #2 screwdriver to remove all 8 10mm exterior screws on the rear of the device.
-
-
-
After screws have been removed, open fan up. Inside remove the black and silver directional fins.
-
-
-
-
Find and locate the 10 mm screws on both sides of the circuit board enclosure. Remove both screws.
-
-
-
Look inside the frontal shell of the fan and locate power button.
-
Remove by gently pulling button off notch and replace with new power button.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Rückgängig: Ich habe diese Anleitung nicht absolviert.
2 weitere Nutzer:innen haben diese Anleitung absolviert.
Team
USF Tampa, Team S1-G1, Nance Fall 2017 Mitglied von USF Tampa, Team S1-G1, Nance Fall 2017
USFT-NANCE-F17S1G1
3 Mitglieder
4 Anleitungen geschrieben
