Änderungen an diesem Schritt
Bearbeitet von Luke Farmer –
Bearbeitung genehmigt von Luke Farmer
- Vorher
- Nachher
- Unverändert
Schritt-Zeilen
| + | [* black] Turn Off and Unplug the Keyboard Ensure the keyboard is completely powered off and disconnected from any power source before starting. |
|---|---|
| + | [* black] Remove Screws (12 Phillips #1, 7.5mm) Use a screwdriver to remove all screws from the back panel. Some screws might be hidden under rubber feet or other parts, so be thorough. Keep track of the screws to make reassembly easier. |
| + | [* black] Open the Case Gently lift the top panel of the keyboard to expose the internal components. Be careful of any ribbon cables or connectors attached to the panel—you may need to disconnect them to fully remove the top. |
| + | [* black] Remove the Old Power Switch (2 Phillips 1 Size: 5.5 mm) Heat your soldering iron and use a desoldering braid or pump to remove the solder from the pins of the old switch. Once the solder is removed, gently pull the old switch out of its place. |
| + | [* black] Prepare the New Power Switch If the replacement switch doesn’t have pre-attached leads, you’ll need to solder wires to it. If it has leads, align them with the matching holes on the PCB where the old switch was connected. |
| + | [* black] Solder the New Power Switch Position the new switch in place, ensuring the leads align correctly with the pads on the PCB. Solder the leads securely, using just enough solder to create a strong connection without any excess that might cause shorts. |
| + | [* black] Reassemble the Keyboard Once the new switch is soldered in, reconnect any cables or components you removed. Carefully replace the top panel and secure it with the screws. |
Bild 1
Kein vorheriges Bild
Hinzugefügt
Bild 2
Kein vorheriges Bild
Hinzugefügt
Bild 3
Kein vorheriges Bild
Hinzugefügt