re : Notification Diffuser

There is a little part that dropped out during this procedure, but not covered here.

It’s the Notification Diffuser, a little semi-translucent piece of whitish rubber about 3mm sqr.

It goes on the underside of the midframe (not in any photo here), at the top of the phone, just to the left of that centimeter wide well or hole in the motherboard, as you’re looking at the motherboard with the phone open.

It’s right near the farthest left brass “dot” in Figure 13’s photo.

It covers the Notification light.

There is mention of it on this youtube :

https://www.youtube.com/watch?v=UdenXVWz... (Not in English but you’ll here a word that sounds like “Diffuser” as he points it out.

Thanks astroguy !

I was going to ask . . . After getting it open, can anyone see what actually latches it together so with that knowledge, later attempts might be easier ?