Hello Eliana, Sounds like the software crashed. Also I understand you have held the power button long enough. However not sure if if you did it without being plugged in or not. Hear is what to do -Making Sure Your Tablet Is Not Plugged Into a Power Outlet -Hold the power button for 30 seconds to force a power down. This helps if the software is stuck in a loop and is not responding to the power button. A long hold on the power button activates a hardware power off. Since you left it charging all night and part of the day, this should work. Also the unspecified tablet may have a factory reset function. This can resolve a software lock up, but may clear your data from the tablet. Good luck, Adam Carrillo

Hello Petrus, Here is what to do first: Check to see if a household circuit breaker or Ground Fault Circuit Interrupt (GFCI) outlet has tripped. If so, reset the circuit breaker or Ground Fault Circuit Interrupt. If the refrigerator is on a fuse box, check to see if a fuse has blown and replace it, if necessary. Should that not work for you, Check the following : Make sure your refrigerator is plugged in to an electrical outlet by itself. Big appliances tend to draw more electricity and when connected with other appliances running within the same electric line can cause a power overload, causing the breaker to trip. This happens quite often when a Microwave is running in conjunction with other appliances such as, an electric cloth Dryer, washer or many times even a hair dryer may cause the breaker to trip. Lastly I recomend a Refrigerator Reset. It is very easy to do and doesn't take that long. Here's what to do, Refrigerator Reset: Unplug your refrigerator power cable from the electrical outlet for an...

Go to Device Manager and on the list of devices check for any devices ending with an exclamation point and delete them. Now click refresh at the top left or collapse n uncollapse the libraery or simply Reboot your system. Do not worry, this will not delete any device this will refresh the drivers back to their normal state. all Device Manager Drivers are stored in your operating system and reloads them on a refresh or if deleted. When u reboot make sure the cable is connected so your system picks it up. if you are plugging to a tv or monitor, you must let your system know by going into the Display window in Settings and checking off the Add secondary Display in this section you can also mirror or deside wich display should be primery. Lastly Should the above not work, Check your Cmos, The HDMI feature could be turned off there. if it is, Activate it and hit F10 on your keyboard, pad or screen board. Good luck!

Resisting Maytag Bravos Quiet Series 300 Hello, This should help; You will have to Reset the Spinning mechanism. it appears to be dormant! This normally happens when it is too heavy of a load or when it spins unbalanced usually sneakers are the cause for this to happen or both, making your washing mashine go into protective mode. Resisting Maytag Bravos Quiet Series 300: (1) Set wash dial to NORMAL (2) Turn dial back one click to BULKY SHEETS (3) Turn dial forward three clicks to HAND WASH (4) Turn dial back one click to WRINKLE CONTROL (5) Turn dial forward one click and Stop on HAND WASH (6) all lights should lid at this point and your washer would like to know what it is that you would like to reset and in your case would be your Spin. (7) Now moving right along: (8) (You will now move your Maytag Washing Cycle DIAL) (9) Turn Dial forward and go (PASSED... COLD WASH and RINSE & SPIN) Stop at DRAIN & SPIN. * this will reset all spin issues With today's technology you may also do the following, should you...

0.2mm diameter solder ball placement in 0.35mm pitch. Hope this helps.