Werkzeuge
Ersatzteile
Keine Ersatzteile angegeben.
-
-
-
-
-
-
Using the Phillips #00 screwdriver, remove the two screws near the top of the device.
-
-
-
Using the Phillips #00 screwdriver, remove the two screws located inside the battery compartment.
-
-
-
Partially separate the two halves of the case by inserting the tip of a small flat head screw driver into the space between the halves.
-
-
-
-
-
Using the #00 Phillips screwdriver, remove the screws from the corners of the screen. There are 3 screws total.
-
-
-
Lift the tab on the motherboard and pull out the ribbon cable.
-
After the ribbon cable is detached from the motherboard, the touch screen is completely separated from the device.
-
-
-
Using the #00 Phillips screwdriver, remove the screws on the back of the front case. There are five total.
-
-
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.