HP Chromebox J5N50UT Hard Drive Replacement
Einleitung
Zu Schritt 1 der AnleitungIf the hard drive of your HP Chromebox is damaged, it is easy to replace. This guide will take you through the steps of replacing the hard drive. For this guide, you will need the Phillips #1 screwdriver.
Was du brauchst
Werkzeuge
Mehr anzeigen …
-
-
Position the device upside-down on a flat, level surface with the USB ports facing you.
-
-
-
Using your metal spudger, lift and remove the 4 rubber “feet” from each corner.
-
-
-
Using your Phillips head screwdriver, remove the four Phillips M2.5×4.0 screws that secure the bottom cover to the computer. In this step the usage of the magnetic mat will be helpful to keep up with the screws.
-
-
-
Insert the flat end of your metal spudger under the bottom cover near the USB ports, then pry the bottom cover off the computer.
-
-
-
-
Lift the two pieces of mylar tape from the bracket.
Flag: Confusing Text
in steps 5 and 6 it seems the bottom shield is called a bracket, so by using 2 different names it’s making it seem like we’re missing a piece/part
-
-
-
Using your Phillips #1 screwdriver, remove the four Phillips M2.5×4.0 screws that hold the shield in place.
-
-
-
Insert your spudger into the gap between the bottom shield and the ports and gently pry to lift and remove the shield.
another picture of where to insert the spudger may be helpful. which ports are you talking about?
Flag: Needs More Images
another picture of where to insert the spudger may be helpful. which ports are you talking about?
Flag: Missing Details
a note step on paying attention to how the shield is positioned before removing it may make reassembly easier
-
-
-
Disconnect the white and black antenna cables from the module.
Flag: Markup Mishap
iFixit has in their Milestone 3 instructions to not use arrows. we recommend either a box over each connector or a rectangular box over the 2 instead
-
-
-
Using your Phillips #1 screwdriver, remove the M2.0×3.0 screw from the upper left corner of the module.
Flag: Needs Better Images
we don’t think picture 2 is needed at all.
picture 3 doesn’t really show how the module has popped up. the angle is wrong to make it obvious
-
-
-
Remove the Phillips M2.0×3.0 screw.
Flag: Missing Details
more information about which screw and where it’s located could be helpful. if you don’t look at the pictures there’s no way to tell which screw is indicated or which component is the hard drive
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Rückgängig: Ich habe diese Anleitung nicht absolviert.
3 weitere Personen haben diese Anleitung absolviert.
Team
Ohio State, Team S1-G3, Whitney Fall 2018 Mitglied von Ohio State, Team S1-G3, Whitney Fall 2018
OSU-WHITNEY-F18S1G3
2 Mitglieder
5 Anleitungen geschrieben
2 Kommentare
actually you can flip open metal bracket with just one mylar tape
and there is 5 screws, not 4. if you look, you will see triangle arrow stamped on bracket indicating which screws to remove.
you can swap the ssd without removing the wifi board
do this all the time, saves a lot of steps
both for the cover replacement and shield replacement
Ian Stoffel - Antwort
For the hard drive replacement, a longer times should be indicated. for the WLAN replacement 15 minutes is indicated, but for the hard drive replacement, which can only be done after the WLAN replacement, the time is listed as 10 minutes.
Ian Stoffel - Antwort