Samsung Galaxy S23 Ultra Wireless Charging Coil and Loudspeaker Replacement

Zuletzt aktualisiert am January 29, 2025

30 - 45 Minuten

Mittel

Grundständige Anleitung

Dies ist eine grundständige Anleitung, die nur als Teil einer anderen Anleitung verwendet werden sollte.

Einleitung

This is a prerequisite-only guide! This guide is part of another procedure and isn't meant to be used alone.

Werkzeuge

Use the pointed end of a spudger to pry up and disconnect the NFC antenna press connector from the motherboard.
Repeat for the wireless charging coil press connector.
To re-attach press connectors, carefully align and press down on one side until it clicks into place, then repeat on the other side. Don't press down on the middle. If the connector is misaligned, the pins can bend and cause permanent damage.

The wireless charging coil is lightly adhered to the battery.
Insert an opening pick between the right edge of the wireless charging coil and the battery.
Slide the pick along the right edge to separate the adhesive.

Insert an opening pick between the top edge of the wireless charging coil and the frame.
Slide the pick toward the right edge to separate the remaining adhesive.

Use a Phillips screwdriver to remove the five 3.5 mm-long screws securing the NFC antenna and charging coil.

Use a Phillips screwdriver to remove the six 3.5 mm screws securing the loudspeaker.

Insert the pointed end of your spudger between the upper right corner of the loudspeaker and the frame.
Pry up to unclip the loudspeaker from the frame.
Don't pry against the battery. Use protrusions in the frame for leverage.
During reassembly, press around the perimeter of the loudspeaker to clip it to the frame.